الوصف
شاشه للعمل مع PLC -عدد 2 سطر TEXT
Without testing all PLC boards, the seller does not provide additional technical support.
The display board takes up PLC of the following resources, please pay attention to PLC programming
Dimensions: length * width * height 105 * 53 * 19MM
Opening size: 101*51.5MM
Use this simple text in PLC ladder diagram programming example
Simple operation, no programming, high cost performance, and my company with PLC, the project development cycle is short, stable circuit, can replace the traditional counters, timers, text, touch screen, etc.
Very simple to use, without programming, direct use
A total of two modes,One of the main models, one is the transmission parameter model
A power to enter the main modeIn this mode, the value of D110 on digital display
The lower the value of the D114 digital tube display,
The button switch controls the closing and breaking of the corresponding intermediate relay (M)
The middle part of the relay (M) is closed and off to control the light and destroy
Press the SET key for 3 seconds and then enter the transmission parameter mode
Data register can be changed in the transmission parameter modeD200Future value
Above a row of digital tube (double digital tube plate) or left two digital tube (single row
Digital tube board) used to display the number of data registers to changeUpper triangle
A key (increment) can be changed by pressing the triangle key (decreasing), and when a change is made
Read the value in the digital tube (double row digital tube plate)Or right 4 digit
Tube (single row of digital tube board) display, but also can use the UP key and DOWN
To change the value
When the value is changed, press the SET key for 3 seconds and then enter the main mode
PLC display and transmission parameters display board 0.56 inch digital tube simple text single row display D114 value
Very simple to use, without programming, direct use
A total of two modes,One of the main models, one is the transmission parameter model
A power to enter the main modeIn this mode, the value of D110 on digital display
The lower the value of the D114 digital tube display,
The button switch controls the closing and breaking of the corresponding intermediate relay (M)
The middle part of the relay (M) is closed and off to control the light and destroy
Press the SET key for 3 seconds and then enter the transmission parameter mode
Data register can be changed in the transmission parameter modeD200Future value
Above a row of digital tube (double digital tube plate) or left two digital tube (single row
Digital tube board) used to display the number of data registers to changeUpper triangle
A key (increment) can be changed by pressing the triangle key (decreasing), and when a change is made
Read the value in the digital tube (double row digital tube plate)Or right 4 digit
Tube (single row of digital tube board) display, but also can use the UP key and DOWN
To change the value